Current location:
Calculation of wall thickness for thick plastic sheets, and plastic molding parts

Wall thickness calculation, blister molding parts


        When the thickness of the unformed material is known, we can roughly estimate the thickness of the thermoformed part. Due to the irregular distribution of the design wall thickness and the final forming wall thickness of the part, the final calculation result should consider a ±30% wall thickness distribution. For this calculation, it must be assumed that the volume of the material remains constant throughout the entire forming process.  


        Therefore, the following holds: V1 = V2


        Thus: F1·s1 = F2·s2


        Therefore: s2 = F1/F2·s1


        In the formula, Vl represents the volume of material excluding the clamped edge;  


        V2 - Volume of thermoformed parts;  


        F1 - Material area without clamping edges;  


        F2 - surface area of the part; s1 - thickness of the raw material; s2 - wall thickness of the part.  


 Example of wall thickness calculation:


 ① Determination of wall thickness of rectangular molded parts


According to Figure 3-21, the dimensions are as follows:


a=800mm, b=500mm, c=400mm, L=880mm, B=580mm


Using these data to calculate the area and area ratio, we obtain:


F1 = L · B = 510400mm2


F2 = L · B + 2bc + 2ac = 1550400 mm2


F1/F2 = 0.3293???? F2/F1 = 3.0367


For molded parts made of raw material with a thickness of s1=4mm and a uniform thickness distribution, the wall thickness is:


s2 = F1/F2·s1 = 0.3292X4mm = 1.32mm 


Due to the uneven fluctuation in the wall thickness of molded parts, the actual thickness distribution of the products ranges from 0.9 to 1.7mm


s2act = s2±30% = 1.3mm±0.4mm ≈ 0.9~1.7mm


② If the wall thickness of the fabricated part is specified, the thickness of the required material is determined


According to the average thickness of the fabricated part shown in Figure 3-21, which is s2 = 2mm, what should be the thickness of the required raw material?  


The calculation results of material thickness are as follows:


s1 = F1/F2·s2 = 3.0376X2mm = 6.075mm


Due to the irregular distribution of wall thickness in the fabricated parts, the thickness of the selected material should be increased by 30% compared to the calculated value


s1act = 6.075+30% ≈ 8mm