Current location:
Thick plastic pieces will inevitably have imperfections

Due to the process characteristics of vacuum forming, especially for thick plastic parts, there are unavoidable flaws:


 After vacuum thermoforming, the material thickness will be reduced, resulting in a decrease in transparency for transparent parts. Although it may not be visible to the naked eye, it can be detected by a spectral analyzer.   


 2. During the production process of blister products, small substances such as dust in the air may come into contact with the heating material, or the material itself may contain impurities, resulting in the formation of particles or crystallization points. When these crystallization points are too large or too numerous, they can cause defects such as pitting on the blister parts, especially in transparent blister products. Therefore, special attention should be paid to the hygiene of the production environment and to quality control during material procurement.  


 3. In the production process of blister products, due to the numerous manual steps involved, friction is prone to occur, and scratching on the surface of blister products is a common phenomenon. Cutting and packaging are the most critical links, and workers must pay special attention during operation.   


 4. Due to the asymmetric shapes and uneven heights of the blister material during production, uneven thickness may occur during stretching.   


 5. During the production process of blister products, due to the presence of small amounts of air or moisture in the heated plastic material, tiny bubbles are formed in the produced blister sheets, resulting in perforation and wall breakage of the product